George the quality of the idle is controlled by the butterflies close to
the rotor housing. I does not matter what happens below 5000 RPM in
a geared aircraft engine. I have driven this car with P-ports
and they work just fine. The third picture is a street driven P-port
engine.
Just build one and try it.
Paul Lamar
Paul,
You know what - your probably right!!
>From discussions with Lynn, he has similar feelings on this matter, but it
has only been just recently that I sufficient information to enable me to
feel comfortable enough to test the theory - and that all that came from
discussion !
I am now feeling comfortable that anywhere from IO 100 degrees just past
the wall of the bottom adjacent bolthole (can't go any lower than this) - to
IC 85 degrees upper end of the unused bolt hole (extreme limit) will do the
job and the motor will run well enough at idle.
So both Jerry's and Richards ports will run OK.
Port opening shape also has a bearing on helping to eliminate mixed exhaust
gases that dilute the intake charge and causes rough idle.
But which one is the best !? - just joking Paul, I'm very comfortable with
the knowledge gained.
George (down under)
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.