Subject: oil pan dim.
From: ACRE
Date: 6/15/2004, 8:37 PM

Edward Klepeis wrote:

Dear Paul
       Jerry said you might have the dim. on the front and the back  of the oil pan to establish the angle of the pan.This angle is the same as the inlet
duct.I have an idea on a alum. oil pan but I just don't want to make something that doesn't fit . thanks for your help

Regards

Ed

techwelding@comcast.net

You must of read my mind. I was thinking about you today. I need
a couple of rear motor mount tabs welded to the back panel of 
my oil pan and I was thinking of send it to you. 

The thing to worry about is the oil pick up screen.
Here is drawing of my pan unfortunately the oil pick up screen
hits the bottom. So make it about and inch deeper. You
do have an engine there you can try a cardboard mockup on.

I can redraw this if you need me to. The reason the oil pickup
tube hits is I did not have Rhino in those days :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.