Subject: Not just rings. RE: Petroleum. Break In Oil
From: ACRE
Date: 6/16/2004, 9:13 PM


Not much info there. Actually I don't buy it.
there is no part in the rotary that wears like that. For all practical
purposed the bearings in a rotary last for ever. The apex seals
have a linear rate of wear and then the seals must be replaced
and perhaps the apex seal slots in the rotors reground for  a wider
apex seal. That might hold for a monkey motion piston engine where slop
causes one part to impact another or its bearing in the block. The more
the slop the greater the impact. Typical for reciprocating
mechanisms.

Paul Lamar

Paul,
The only place where the rotary "breaks in" is the side seals.
They are a linear wear item as well, and even lower than the modern tip seal. Since the lube oil for the tip seals is injected, (or pre-mixed with fuel), there is really no need for a break in lube. Clean and deburr all parts of your engine before putting it togeather! Modern race engines rarely see more than a 20-30 minute break in, some dyno time and tuning and GO!
Bill Jepson

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.