Jerry Hey wrote:

Paul,   I am trying to determine the exact height of the Barry Mount
measured from  the prop center line in order to modify the fixture.
Looking at the "box=schertz3-2D. jpg"   the bottom of the box  beam is
not even with the bottom of the pan rail but is a little above it.  Can
  you give me this exact measurement.   Thanks,  Jerry

Not yet Jerry. the beams are being made. You need to drill them out
and weld in the steel spacers. One of which will be drilled out to accept
the hollow dowel pin in the stock rear end housing.
Here is a drawing but don't take it as the gospel truth just yet.
BTW one spacer can be 3/4 OD and the other about 5/8 OD.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.