<< 20 3 rotor engine

Is this engine in production? Where can I find information on it?
F Meyers

Not currently in production but can be built up from all new parts.
Ask any questions on here.

Paul Lamar

Contact Bruce Turrentine below. He can build you a new 20B with 13B rotor
housings from new parts.

http://rotaryresources.com/

Lynn E. Hanover

How does he get a new E-shaft.  Is it from Mazda or does he manufacture
it?... Thanks!

Regards
James

Its from the Mazda Racing dept.

Mazdatrix probably sells them as well.

Paul Lamar

Douglas Fir wrote:

So soon we should be able to make a 20B from Renesis side port parts and use
the aluminum front and rear housings from Racing Beat?

Doug in Japan

All the cast iron parts are there except the side port 20B specific intermediate
housings. The Racing Beat aluminum end housings are still peripheral exhaust port
unfortunately. Lots of money could change that.

Paul Lamar

Thanks for the information on the E-shaft. I am quite curious about
building a 20B from 13B parts.  However,  I have not has any personal
experience with the rotary: thus, I will have to learn more about how to
go about this and what additional parts are needed, as well as parts
sources.  You mentioned the 20B specific iron housing.  I am sure
counter balances are also required.  Would you please advise me if such
and/or any other 20b specific parts are available and their possible
source.  I hope this isn't to much to ask.  Thanks!

James

Regards

True special counter balances are also required but they could be easily
made if necessary. Here is a combination counter balance and starter ring
gear made for the 13B by Power Sport.


Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.