The best configuration for aircraft use would be an all aluminum
turbo
compound rotary engine optimized for low fuel consumption in the
5000
to
6000
RPM cruise range. Firstly an RX8 based two rotor engine but an
RX8
based
three rotor version would also be wonderful of course. These
engines
would
dominate the less than 600 HP aircraft engine market given enough
marketing
muscle. Above that HP range the turbo prop engine starts to make
more
sense.
There is some engineering opinion that a large turbine connected
directly
to the
e-shaft is not the way to go. I would like to see it tested
however.
It is certainly the simplest way of building a turbo compound
engine.
Paul, after looking at the attached JPEG, I'm wondering if it wouldn't
be easier to drive the turbo-compounder from the ring gear on the
flywheel? I used to work in the engine plant at Caterpillar -- that's
how they did it.
Regards,
Rob Weinstock
That is interesting Rob. Got any good pictures?. This is the best one I can
come up with of the Cat turbo compound. I would love to have some
better pictures of this engine.
The ring gear will work with a fluid coupling like most turbo compound
engines. You get one heck of a gear reduction there.
Do you happen to know how much reduction in fuel consumption this
turbo compound implementation achieved. Diesel don't have a heck of a lot of energy
left in the exhaust like rotaries do.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.