Subject: Air cooled tangentail muffler.
From: ACRE
Date: 6/23/2004, 3:15 PM


It might have been three years for you but I knew all along it would
work fine :) The only thing I needed to fix was the area under the
back (front AC)
of the engine where the cooling air found its way to the rad :)

Add a fish tail on the outlet pipe to quiet it some more.
Here is a 3D of a tuned muffler with fish tail. Actually I think
you have room for one of these tuned mufflers. Ed made a fish tail
and had it at Sun & Fun.


Red scat hose is only good to 500 degrees F on a good day. I would
keep it
steel for as long as possible so it can cool off at the end you connect
the scat hose. The muffler runs up to 1750 F. Particularly right
at the two points where the tubes come out of the engine and are
pointed
at the can. If it fails.... that is where it will fail first.

You could connect it to the rad plenum wedge. That should shorten the
connection.
Be prepared to move it if it doesn't work.

Paul Lamar

I knew we would get there but it has not been easy.  I probably have
fifty versions of the TW engine mount on file.  Most of  the useful
ones were drawn by you.

   That scat hose is carrying cold air.  I don't think it will get very
hot. It will be interesting to see what temps we actually record in the
muffler.  I think they will be a lot lower than what they have been.
About the tuned tangential,  I talked to Ed about building it.   We
have more questions than answers.   I think I could make one for around
$5000.00 labor.  Jerry

Well maybe not THAT much :) You have got to be creative about what order
you weld it in. I think Brian Trubee came up with the hot tip on how
to build it out of flat sheet. On the other hand it is probably too hard
for you amateurs :) ........ Just kidding.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.