Subject: Air cooled tangentail muffler.
From: ACRE
Date: 6/23/2004, 11:04 AM


OK Jerry,
Feeding cool air into the back will fit fine.
That is a 3 inch center line radius 2 inch steel tube 180 degree
bend.
Just don't run the engine full power static too long
as I suspect it won't get as much cooling air as if
it were going 200 MPH.


Paul Lamar

Based on  your drawing it looks like we are talking about different
things.   The cool tube is a pipe that runs thru the muffler.  It will
be fed  continuous cool air via a scat hose from a NACA (maybe) inlet
on the belly. The air will enter the rear of the tube and exit the
front.   Originally I wanted to bring the cool air from the nose bowl
area but the new  Schertz beam location blocks that.   The cool tube
increases the surface area of the muffler tremendously and since it is
provided with  a steam of outside air it will significantly knock down
the exhaust temp.  So far no one is as excited about this as Ed and I
but we  think if is pretty neat.      Jerry


Take another look. I am feeding it from the back side. Yes there is a
cool tube.
We are talking about the same thing Jerry. There is no room to feed it
from
the bottom. What I have shown is feeding it over the top from a hole
in the front of the cowl. That will pump more air anyway than a NACA
duct on the bottom. You don't want to put a small P51 type duct on the
bottom do you?

Paul Lamar

O.K.  There is an optical illusion with the drawing at least when I
look at it.     Taking the air from the nose is better.  Can we not
make the 180 bend with scat  hose?

Can we  now say with confidence that we have a motor mount concept and
an exhaust system that can coexist?  Jesus,  what a battle this has
been.  At least three years of more or less continuous effort to get to
this point, just on paper.   Of course we have not won yet.   I think
the "free flowing" exhaust will do o.k. power wise, but until it is
fired up, we won't know if  the engine has been quieted sufficiently.
   Jerry

It might have been three years for you but I knew all along it would
work fine :) The only thing I needed to fix was the area under the back (front AC) 
of the engine where the cooling air found its way to the rad :)

Add a fish tail on the outlet pipe to quiet it some more.
Here is a 3D of a tuned muffler with fish tail. Actually I think
you have room for one of these tuned mufflers. Ed made a fish tail
and had it at Sun & Fun.

 
Red scat hose is only good to 500 degrees F on a good day. I would keep it
steel for as long as possible so it can cool off at the end you connect
the scat hose. The muffler runs up to 1750 F. Particularly right
at the two points where the tubes come out of the engine and are pointed
at the can. If it fails.... that is where it will fail first.

You could connect it to the rad plenum wedge. That should shorten the connection.
Be prepared to move it if it doesn't work.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.