Subject: Air cooled tangentail muffler.
From: ACRE
Date: 6/23/2004, 8:20 AM


OK Jerry,
Feeding cool air into the back will fit fine.
That is a 3 inch center line radius 2 inch steel tube 180 degree bend.
Just don't run the engine full power static too long
as I suspect it won't get as much cooling air as if
it were going 200 MPH.


Paul Lamar

Based on  your drawing it looks like we are talking about different
things.   The cool tube is a pipe that runs thru the muffler.  It will
be fed  continuous cool air via a scat hose from a NACA (maybe) inlet
on the belly. The air will enter the rear of the tube and exit the
front.   Originally I wanted to bring the cool air from the nose bowl
area but the new  Schertz beam location blocks that.   The cool tube
increases the surface area of the muffler tremendously and since it is
provided with  a steam of outside air it will significantly knock down
the exhaust temp.  So far no one is as excited about this as Ed and I
but we  think if is pretty neat.      Jerry


Take another look. I am feeding it from the back side. Yes there is a cool tube.
We are talking about the same thing Jerry. There is no room to feed it from
the bottom. What I have shown is feeding it over the top from a hole
in the front of the cowl. That will pump more air anyway than a NACA
duct on the bottom. You don't want to put a small P51 type duct on the
bottom do you?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.