Jerry Hey wrote:

Paul,  FYI,  I measured the end housing sent by Perry re the Sbeam.
The bolt centers are 8.941 inch apart and the right hole is offset
0.712 inch up.  You probably already have this data but no harm in
double checking.   Jerry

It will be up to you to drill the holes. You now have a box beam 2
inches high
to work with. The total height using .75 spacers will be 1.462. That
will leave
you about a 1/4 below the top for the upper spacer and a 1/4 inch
above the bottom
for the lower spacer. Should be no problem.

Paul Lamar

The beam as shown in the drawing is in two halves.  Is there a welded
seam full length top and bottom (with cut out for the fly wheel)? I was
expecting a beam that had only one seam on the top.   Also the width of
the beam is 2.60 in, not 3.05.  How do we keep it from floating back
and forth on the spacers?   Can I have the DWG version of this drawing?
  Thanks,   Jerry

Sorry Jerry that Drawing is obsolete. The beam is in one peice with 
a slot in the top for the flex plate.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.