Edward Klepeis wrote:

Dear Paul
      Could you give me the exact location  on the extention  on the bottom of the oil pan, round. sq.,etc. and how deep.

Regards
 P.S I am working on your oil
pan
Ed

techwelding@comcast.net

You will have to remove your oil pan and check for pickup tube/screen clearance
by installing my pan on your engine. Use a bit of clay in there and the
problem area will be identified. Or cut a large hole in the bottom of my
pan and then install it on your engine.

Round or square your choice. Make it about 1/2 inch deeper than the screen.

Paul Lamar

"Lemings, Bob" wrote:

Paul,

Another dumb question:  What happens to the oil supply to the engine when the aircraft is vertical or upside down, as in looping or rolling?  (Ground loop excluded-- too late to worry at that point :).

Bob

For aerobatics you need a dry sump system designed for aerobatics. 

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.