Edward Klepeis wrote:
Dear Paul
Could you give me the exact location on the extention on the
bottom of the oil pan, round. sq.,etc. and how deep.
Regards
P.S I am working on your oil
pan
Ed
techwelding@comcast.net
You will have to remove your oil pan and check for pickup tube/screen
clearance
by installing my pan on your engine. Use a bit of clay in there and the
problem area will be identified. Or cut a large hole in the bottom of
my
pan and then install it on your engine.
Round or square your choice. Make it about 1/2 inch deeper than the
screen.
Paul Lamar
Would it be possible to trim and remark the dip stick? To make my pan
deep enough for the dip stick, I installed the dip stick with the pan
off and measured the depth required with a square across the pan rail.
Also, if using a round hole for the dip stick, the hole should be
set in toward the center of the engine so that the dip stick just
clears its outside edge. If the hole is centered, there will be a gap
where the side of the pan contacts the oil/air sep plate. This is a
weld seam. Attaching photo of my oil/sep plate that shows the hole
squared off on one side.
Also, how important is the screen on the end of the pick up tube?
Mine just touches the pan bottom. I had to dent the screen with my
finger. No problem installing the pan, but I have been tempted to
remove the screen. Jerry
I would not do that. Particularly with the PSRU using the same oil.
You want to keep the cutting tools out of the engine :)
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.