Subject: Engine rebuilding advice sought: seal trimming
From: ACRE
Date: 6/24/2004, 7:41 PM



This message and any attachments are solely for the intended recipient and may contain confidential or privileged information. If you are not the intended
recipient, any disclosure, copying, use, or distribution of the information included in this message and any attachments is prohibited. If you have received
this communication in error, please notify us by reply e-mail and immediately and permanently delete this message and any attachments. Thank you.

-> "Weinstock, Rob" wrote:

Hello,

I'm about to rebuild a 13B, normally aspirated. There is some text in the factory service manual and also in the Mazda Competition Parts catalog about the
proper way to set seal length and clearance.

Can somebody provide some straight guidance on what needs to be done to insure that the seals are fitted properly?

Many thanks and regards,

Rob

Other than what is in the over haul manuals I have no idea. If turbo however I do
recommend two piece 3 mm seals. Also check the wear on the rotor slots with new 2 mm seals.
If it is excessive or out of new spec have the slots ground out and use 
two piece 3 mm seals.
 
Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.