Subject: oil pan bottom extention
From: ACRE
Date: 6/24/2004, 6:37 AM


Edward Klepeis wrote:

Dear Paul
      Could you give me the exact location  on the extention  on the
bottom of the oil pan, round. sq.,etc. and how deep.

Regards
 P.S I am working on your oil
pan
Ed

techwelding@comcast.net

You will have to remove your oil pan and check for pickup tube/screen
clearance
by installing my pan on your engine. Use a bit of clay in there and the
problem area will be identified. Or cut a large hole in the bottom of my
pan and then install it on your engine.

Round or square your choice. Make it about 1/2 inch deeper than the
screen.

Paul Lamar

"Lemings, Bob" wrote:

Paul,

Another dumb question:  What happens to the oil supply to the engine
when the aircraft is vertical or upside down, as in looping or rolling?
(Ground loop excluded-- too late to worry at that point :).

Bob

For aerobatics you need a dry sump system designed for aerobatics.

Paul Lamar

Bob,
Unless you are planning to fly around inverted or like negative G outside
loops, you don't need to worry about it.
A few second aileron roll won't hurt anything.

Ron Freier

Aren't you weightless for a few seconds at the top of a loop or is it all
positive G's. I get sick doing aerobatics.

Paul Lamar

"Lemings, Bob" wrote:

I definitely do not like negative G's (things get really weird when everything starts turning red), nor do I like to be inverted for more than a second or two.  I participate in induced spins, but I can't say that I like them--- when your skin gets looser with age, those pull-outs make you feel like your cheeks are lying on your chest.  Seriously though, very mild aerobatics is all I would ever attempt.  I don't even care much for 60 degree banks unless I have the controls-- then it doesn't bother me.  Same thing in a car- I hate to ride at high speeds as a passenger, but there is no limit if I have the wheel.

Bob

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.