Jerry Hey wrote:

Paul please consider the attached drawing.  There are two measurements
that are guesses on my part.  One is the diameter of the flex plate. I
am using 12.625 inch in the drawing.    The other measurement I don't
know is the distance from the prop center line to the pan rail.    I
have been using 6.75" which I got from the Mazda Side View JPG which
was published on ACRE.   It is closer to 6.25 inches.   Do  you have
the actual measurement?   Otherwise,  does this drawing represent what
we want to do?   Jerry

I would go with the 6.25 number.

The rest of it looks good.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.