Edward Klepeis wrote:
Dear Paul
Could you give me the exact location on the extention on the
bottom of the oil pan, round. sq.,etc. and how deep.
Regards
P.S I am working on your oil
pan
Ed
techwelding@comcast.net
You will have to remove your oil pan and check for pickup tube/screen
clearance
by installing my pan on your engine. Use a bit of clay in there and the
problem area will be identified. Or cut a large hole in the bottom of my
pan and then install it on your engine.
Round or square your choice. Make it about 1/2 inch deeper than the
screen.
Paul Lamar
OK Ed here are the revised dimensions. Deeper oil pan.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.