Brice Cottle wrote:
Is there anything short of rebuilding that can be used to free stuck
rotor seals on a RX-7 engine after it has set?
Thanks in advance
Brice
Cottle
autosp@socket.net
You can try soaking the inside in auto tx fluid for a few days.
If you can get the exhaust manifold off you can get to the seals with
your fingers and see if they are free. Also squirt some WD 40 in
there.
Paul Lamar
-Terry Wilson wrote:
Paul and others,
Try Kroil by thr Kano corporation. Their product creeps down to a
millionth of an inch.
Compared to it's competition it's amazing. Also comes as an aerosol
known as aerokroil:)
Terry-
Does the Aerokroil version cost ten times more?
PB Blaster is another excellent penetrator. Somtimes if you can get
the engine to run that can get them loose. A 13B will run with only
one rotor face. Turn the engine over to line up each apex seal with
the exhaust port and you can push on the each apex seal with a
screwdriver and see if they move. Spray penetrant directly, strike
with a punch, heat with a torch, all are options.
Francois, I hope this is a area of concern for you guys, considering
how few hours many planes are flown. I would hate for your (our)
engines to get a bad rep for something so simple. I have seen this
phenomena a LOT in the cars. I have always been intrigued by the
Hurley idea of feeding oil straight into the apex seal slot, but still
haven't actually implemented it on any engine I have built. It seems
to me that this lubricates the apex seal slot better than any other
method. This and/or two stroke oil in the fuel and/or ceramic apex
seals could mean a much higher TBO than you are shooting for IMVHO. Is
Mistral going to go with ceramic apex seals? I'm thinking that ceramic
apex seals would not be prone to sticking.
Hans Conser
Network Chiropractor
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.