Hi, fellow rotary enthusiasts....I am trying to find out if anyone has
located, or is using, an oil temp sensor that is a male pipe plug thread,
ie....1/4 NPT or 3/8 NPT.  That would be the simplest installation for me.
Any and all suggestions and/or sources would be much appreciated.  I have
run my engine for approximate 10 minute intervals, and the water temp has
been fine, but don't know about oil temp yet, as I need this sensor.  Thanks
in advance for all replies.  Paul Conner, 13b powered SQ2000 canard

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.