Mobil One is highly unlikely to cause the apex seals to stick. I do know
from my own test that it will survive 500 degree F while regular motor
oil goes to gum at around 300 degrees F.
Unfortunately there is no quick way to test Mobile One long term with
the variety of fuels likely to be burned in a rotary and that includes Jet
A
and diesel fuel. If it were me I would specify Mobile One and forget
mixing
two cycle oil with the fuel providing of course pilots are really dead
set against mixing two cycle oil with the fuel.
Has anybody on here had problem with apex seals sticking while using
Mobile
One long term? I used it in my 2nd First Gen RX7 and it sometimes went
weeks with being driven. I am using it now in my RX8 but I only have
10,000
miles and it rarely goes longer than about two weeks without being driven.
Paul Lamar
Paul,
I'm confused!!
Are you advocating forgetting using the 2 stroke altogether and running the
synthetic through the metering pump for the apex seals.
I thought you tested the synthetic and it left a bad residue when burnt ?
I've been advised by others, that synthetic takes much longer to burn and
therefore does a better job on the apex seals - are you now of the same
opinion?
George (down under)
Only in francois case where he is concerned that pilots will balk at mixing
two cycle oil with the fuel.
"I thought you tested the synthetic and it left a bad residue when burnt ?"
I don't know how you got that wrong impression. The only thing that beat Mobile
One in my heat test was synthetic turbine oil.
BTW try this yourself. Place a teaspoon amount of oil in a steel can and
heat it in a preheated oven at 500 F (260C) for one half hour.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.