Subject: Stuck seals, question for Francois
From: ACRE
Date: 6/29/2004, 4:06 PM


Paul,
I'm confused!!
Are you advocating forgetting using the 2 stroke altogether and running
the
synthetic through the metering pump for the apex seals.

I thought you tested the synthetic and it left a bad residue when burnt
?

I've been advised by others, that synthetic takes much longer to burn
and
therefore does a better job on the apex seals - are you now of the same
opinion?
George (down under)

Only in francois case where he is concerned that pilots will balk at
mixing
two cycle oil with the fuel.

 "I thought you tested the synthetic and it left a bad residue when burnt
?"

I don't know how  you got that wrong impression. The only thing that beat
Mobile
One in my heat test was synthetic turbine oil.

BTW try this yourself. Place a teaspoon amount of oil in a steel can and
heat it in a preheated  oven at 500 F (260C) for one half hour.

Paul Lamar


Paul,
Thanks for that clarification, I kind of felt that was the direction but was
unsure.
It would be good to know for sure with an engine running and injecting  the
Mobile ! and then pulled down for inspection.

Anyhow I will try that heat test - it will give the wife something else to
complain about, then again maybe I'd better not use her oven!
George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.