Subject: Carbon Fiber P-Port manifold update
From: ACRE
Date: 7/5/2004, 1:25 AM

Alex Madsen wrote:

I have been doing a lot of drawing this weekend for my manifold design. I have been mainly working on a P-port design because it is the least complicated and
has a large (relatively :) market potential.

There was concern that I had fuel injectors on the hot side of the engine on my last design.  I think that my current design should address this concern while
allowing those that want to experiment with fuel injector placement the ability to do so. Attached are picture of the design. The fuel injector can be
conceivably placed at any location along the manifold runners. The drawing show a single injector boss however double injector bosses are possible.  The fuel
injector boss currently sits at a 45 degree angle to the runners. I plan to use high temperature flame retardant Garolite (fiberglass composite) for the
injector boss. The injector bosses are attached to the CF runners with epoxy at the desired location.  The epoxy will also fill in any gaps. The force trying
to dislodge the injectors, even during a backfire is relatively small because of the small area of the injector hole that goes into the runner. Injectors are
not attached to a fuel rail but rather an injector cap with NPT threads for an AN T fitting. This allows easy customer configuration of injector layout and
eliminates the bulk and custom machining of a fuel rail (of course if you want to use fuel rails you could).    The injector is retained by the clamping force
of 2 bolts that run between the cap and boss.



The manifold runners will likely 2" ID and made of 2 ply carbon fiber and high temperature epoxy. I have not yet determined what I will use for as a form for
the CF. I am leaning towards wax but foam is also an option. The current length of the runners is 21.5" and 25.7" including Jerry's throttle body. The plenum
can face forwards or backwards and has a volume of 1.2 L. I am not happy with the plenums shape and I will probably redesign it one of these days.



As a side note to Jerry

How goes development of your throttle body? Is there any chance of adding a flange to your TB?  It would make attaching intake manifolds much easer.



Alex Madsen

Alex mount four injectors side by side so one fuel rail can be used.
Simplifies the plumbing and makes it more reliable and less prone to
leaks. No injectors on the hot side.

Epoxy manifolds will not work anywhere near a turbo. Turbo's run up to
1800 F. There is not  a resin in the world that will handle anything 
near 500 or 600 F.

Also 2 ply will not be enough to handle back fires.

Have you given any thought on how you are going to mold this manifold?
We would love to have an epoxy manifold but so far the cost of making
a mold and the hand layup labor involved has been out of sight.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.