Do you know of any long ez a with rotary engine?
Kelsey Jewett
Redding CA
There are several in the works. Perry Mick has been flying his for
years. There is a turbo Cozy flying in Florida. Tom Jordan in St Louis
has a Limo EZ. Probably one or two others I have lost touch with.
Paul Lamar
-Joe Hull wrote:
Also George Graham (rx7ez@yahoo.com)has been flying many years with his [Cozy].
Joe Hull
Cozy MkIV #991 (working on Engine & Electrical & Finishing)
http://www.maddyhome.com/canardpages/pages/JoeHull/index.html
You would think so but I never see him at Sun & Fun despite the fact he
lives in Florida. He has had serious problems with his stock Mazda gear box
I suspect.
Paul Lamar
Don't know why he doesn't visit Sun 'n fun, but just heard from him last week. He responded to a thread on the Canard Aviators list regarding cooling of
Rotary engines. He said that his (I think he has an E-Racer) plane is still going strong, still flying, no cooling problems or any other problems that he
mentioned.
Harley
I really don't think he would say anything bad about his own stock gear box
modifications as he is still selling the planes to it I think.
Last time I checked he used the stock gear box output shaft (less than one inch in
diameter) as the prop shaft. Tracy's early gear box had something similar but with
a larger diameter Ford C6 auto TX output shaft. Tracy wisely soon changed to a
much larger diameter prop shaft. Cyclical gyroscopic bending loads on the prop
shaft can approach 600 foot pounds. That is why Lycoming's have 2.25 inch
diameter crank shafts eight or ten inches long in the vicinity of the
prop flange.
The other problem is second gear in the stock RX7 gear box is not up to
continuos use. George stripped it off once as I recall.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.