Every body had a fine time. Perry Mick could not make it up due to weather

Perry Mick wrote:

We took a family trip to Santa Cruz, I wanted to get back home Saturday
afternoon but we didn't get back til Saturday after dark. So my only
option would have been to fly up Sunday morning early, but figured the
weather would have been marginal so didn't try. I was only interested in
the rotary event anyway.

Paul, who gave you the flywheels? Rick Girard modified a Racing Beat
aluminum manual flywheel for me so my prop adaptor will bolt on and
align with it. Thanks to Mike McGee they were delivered to me today. I
had never weighed the parts until today, using a cheap bathroom scale.
The aluminum flywheel with the bolt-on iron clutch surface removed
weighs only 8 lbs. while the stock iron flywheel weighs 23.5 lbs! So by
doing the swap I will save 15.5 lbs.! I'm only a little concerned about
the strength of the aluminum as it's only about 1/4" thick in places.
Talking to Ken Welter at Arlington a year ago he thinks I should stay
with the heavy flywheel.

Perry

I am not sure who it was. It was delivered to the tent during the panel
discussion. Brian or Richard may know. A heavy flywheel is easier on the
direct drive prop as torque pulses are mitigated. If you use the aluminum
flywheel make sure the counter weight is the proper one for your rotors.
Same goes for the cast iron flywheel.

Make a cross section sketch of that aluminum flywheel and I will take a look.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.