Subject: P-port intake tuning
From: ACRE
Date: 7/13/2004, 8:37 AM


<< Richard Konnen wrote:
 >
 > Paul,
 >   If understood correctly. With a variable length intake, as you get
shorter
 > to keep torque up at higher RPM, you loose volume efficiency. Is there a
 > happy medium to this or is there a particular combination that would be
 > needed.
 > Richard Konnen

 Not necessarily. Depends also on pipe diameter. Shorter pipes less skin
 friction drag. Higher RPM, more air, higher velocity in the intake... more
 pipe skin friction drag. Drag is velocity squared. Bigger pipes less skin
friction
 drag for a given amount of air. The amount of air actually getting in the
 engine with a tuned intake system is also affected by the velocity in the
pipes
 so at low RPM you want smaller pipes to keep the velocity up. That is mainly
 applicable to cars that need high HP throughout the RPM range.

 Don't forget HP is torque times RPM so you are not necessarily losing
 HP. The PP rotary breaths so well however HP is a straight line more or less
up to
 the limit of the rotor bearings or somewhere around 10,000 RPM. Assuming of
course
 you change pipe length and diameter :) That is what the RX8 intake system
 does in incremental steps.


How about this?
                                                              RPM   Torque
    RPM X Torque                                   7,400  X  145 = 107,3000
    ---------------------  =  HP
---------------------------------    =  204.3 HP
         5252                                                     5252


Lynn E. Hanover

You want to try reformatting that Lynn? :)


Paul Lamar

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.