Tom what are you flying and what hp do you feel the turbo 20B is
producing
at 28" MAP?
Good question. I'm not an engineer, but if somebody knows the torque
output of a 20B at 5400 engine rpm, they should be able to figure it out.
My PSRU is 2.17 ratio, so the prop is turning just under 2500 rpm and fuel
burn is about 16 gph at 28" MAP and 170 KTAS.
Tom Parkes
20B powered Lancair ES
My guess on the HP assuming a BSFC of .5 is 192 HP.
At .47 it would be 204 and at a BSFC of .55 it would be 175 HP.
I also want to mention that Tom is using an IVO prop which is well known to
have problems with the inner parts of the blade going into a negative
angle of attack at around 170 kts or lower. Tracy Crook and other have verified this.
Notice how the inner parts of the blades are flat. In other words this
part of the blade has a insufficient pitch.
They also have structural problems but that is another story. They remain
popular because of the low price. IMHO this prop efficiency problem can be fixed
at low cost by adding composite cuffs on the inner parts of the blade as shown in
this picture of Tracy Crooks airplane at Sun & Fun. Tom has promised to construct
some cuffs in the near future when he has some time. I look forward
to seeing the improvements if any.
I mention all this because IMHO Tom's Lancair ES potentially has more
speed at the same fuel burn hence better than 12.2 MPG.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.