The best material I have heard of for turbo's is Inconel.
Inconel
is
an option
on a lot of turbo's now adays. I have no idea what the
stock
Mazda
turbo uses.
Paul Lamar
Thomas Parkes wrote:
Paul:
I've been following this turbo failure thread with interest.
Obviously
there is a great deal we do not know regarding turbo longevity
and
operating
limits, but it is just as obvious that one turbo may have limits
quite
different than others.
My Garrett TE-06 does have an inconel turbine and its published
maximum
continuous EGT limit is 1650 F. That is a good thing, because
my
28"
MAP
cruise EGT runs pretty consistently at 1600 F + or - 25 degrees.
Anytime I
have tried leaning it substantially at that power setting, the
EGT
goes
through the roof--to over 1700 F--and I quickly enrich it.
Perhaps there is some way to remap my EFI, but it will take
someone
with
far
more savy than I.
Incidentally, my 20B engine, turbo and prop have been
overhauled.
I'm
currently adjusting Tracy's PSRU to my existing front engine
mounts
and
will
soon begin reassembling everything. I hope to be flying again
in
August.
Tom Parkes
I guess the only way to go is with a high quality aftermarket turbo,
adjusted to the specific engine/airframe/needs. A good story about
this
is
http://www.kitplanes.com/features/ , on the left scroll down to
"Turbo
Power, Part III". Though it goes about a Subaru-Handgrenade, the
Turbo
part
of the buildup seems to tell the tale - and the way to go.
The sizing and matching related to manifold pressure and throttle
opening is
interesting.
Though after observing this newsletter for a bit over a year now, I
definitely do NOT approve of the all the ducting, this could have
definitely
been made more efficient (See the story about the Mustang II in the
Feb.2004-Kitplane).
Thomas J. ;)
What is it about the ducting you don't like Thomas?
Paul Lamar
Okay,
to clarify: The ducting on the Mustang II looks very good to me.
I did not like the missing space behind the radiators on the RV-4 Sub.
In
the engine pic in part 3 it seems there is no exit duct, which means the
air
is just dumped into the cowling area. Though I might have mixed things
up,
as at the same time I ran through "Contact! Alternatice Engines" to look
for
this turbo story!
Lots of messy engine "rooms" there! I guess it is a lack of knowledge on
part of the builders. No finger pointing, I was the same! Just learned a
lot
since!
If the ducting on the Sub-RV4 is fine, I owe an apology to TurboTom!!
Though can't forgive the use of a recip instead of a Rotary!! :))
I admit that I was a big fan of the Subaru before I decided to once and
for
all get the Rotary out of my system, just had to find your site to get
the
truth about the "Apex-seal eating/oil and fuel guzzling/difficult to
repair
and maintain" Wankelmotor! ;))
Mazda needs to put the Renesis into the Mazda 6 !!
Thomas J.:)
I am afraid you will have to scan some of this stuff you are talking about
as I don't get Kitplanes.
Paul Lamar
Already did. Now I just have to "work" it so the whole thing is not to big!
I will send it as soon as I have it together...
Thomas J.
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.