Jameco Electronic has these amplifier kits one of which should work
fine for our purposes. All you need be able to do is solder a printed
circuit board. My guess is the last one down would work the best.

http://www.jameco.com


Paul Lamar

Jerzy Krasinski wrote:

Does anyone know the part number and producer of the knock sensor?
Do they go one sensor to each cylinder , or one sensor per engine is enough?
How do you mechanically install them? What is the preferred place?
Thank you,
Jerzy

06MZ6 061 N3A1 Nippon Denso

Third gens and three rotor engines had one knock sensor per rotor housing.
2nd gen turbo had only one knock sensor mounted on the center housing.

Most late replacement rotor housings have a pad for the knock sensor above
the upper spark plug. A metric bolt is screwed in (just to check the thread). 
The MSD knock sensor and adapter are also shown.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.