Subject: Books on thermodynamics
From: ACRE
Date: 7/25/2004, 6:30 PM


Perry mentioned he wanted an introduction to thermodynamics
and I recommended Marks' Standard Handbook For Mechanical Engineers.
Unfortunately Marks is a good introduction to thermo theory it stops
short of what he really wants to know about heat exchangers.

The other book you need Perry is "Compact Heat Exchangers" by Kays and
London.
Krieger Publishing Company. Not exactly elementary but it is the bible
on heat exchangers.

Paul Lamar

Does it discuss surface radiators at all? That is my interest at the
moment.

Perry


Well it gets down to the nitty gritty were it discusses the heat transfer
>from a metal plate to the air on a micro level. It also investigates
boundary layer
build up. Fred Moreno also mentioned this a few years ago on here.


If you see a rad with fins that look like fig. e it has particularly low
aerodynamic drag and is particularly good from a heat transfer point of
view.
Much lower drag than the more common louvered fins. This is due to the low
boundary
layer build up on the surface of the fins. Only a few companies make them
and
they are more expensive. Might be a good thing for you to try.

I also reread an SAE paper Honda wrote and they said the wall thickness
of the coolant tube was very important but it was hard to keep if from
corroding
through. They were talking about tube wall thicknesses of .2 mm or about
.008 inches if my arithmetic is correct. O too thin :) Never work
for a 90 psi Mazda oil cooler. >

BTW when are you leaving for OSH? Barny mentioned you were coming. I am
leaving tomorrow so the newsletter will be shut down for about a week.

Paul Lamar

Kays & London is *the* bible if you are familiar with all of the thermo
theory and standard heat exchanger designs.  They don't go into theory much
at all.  Rather, they launch right off into relationships between the
various dimensionless parameters (If you think in terms of Prandtl,
Neusselt, Grasshof, Rayleigh, and all the others, then K&L is for you!), and
start graphing whole families of performance curves for all sorts of heat
exchangers.  If you already know all the fundamentals and are heavy into
building heat exchangers, this is the book to use.  Personally, I have to
bone up on HXs every time I crack Kays & London, just because I don't do
heat exchanger design & analysis very often.

Any good textbook on heat transfer & heat exchanger design makes a good
primer and stepping stone to Kays & London.  But be warned... those beasties
cost $130-$200 the last time I checked.

Tom Kendall (yes Paul!  Still lurking)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.