Subject: lean control for stock ecu
From: ACRE
Date: 7/31/2004, 8:27 AM

Perry Mick wrote:

I built a small instrument that I intend to install in a 3.125
instrument hole in the panel.
It has a small digital readout, a pot and a switch. The digital meter
monitors the O2 sensor voltage. The switch takes the airflow sensor
signal and either routes it right back out to the ECU (off position) or
sends it to a variable-gain amplifier and the output of that is sent to
the ECU (on position). The gain of the variable-gain amplifier is set by
the pot. The variable-gain amplifier was made from a quad op-am and can
amplifiy or attenuate for rich/lean control. I just installed this in my
RX-7 yesterday and it works.
It indicates the ECU runs the engine rich at high-rpm/power settings,
just like it does in my plane.
Eventually I will get it installed in my plane, hoping to get better
fuel economy, better range, and less spark-plug fouling with 100LL.

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.