Subject: Misc info gleaned at OSH
From: ACRE
Date: 8/3/2004, 12:00 AM


The hole in the rotor housing is past the point where the rotor seals shut off 
the intake ports so there is some back pressure on the pump. The rotor is starting
to compress the air. Also with a turbo charger you have a positive pressure
of at least 5 psi above atmospheric. The oil inlet to the metering
pump is a an oil reservoir only a few tenths of an inch high subject
only to atmospheric pressure. At altitude, with a flat rated engine,
the pressure in side the rotor housing will be much higher than atmospheric.

In addition to that all engines past 1989 or thereabouts had a separate air supply
that fed air to the metering nozzles through one way valves mounted above the
nozzles. No telling where this air came from and or its pressure.

If I had a turbo I would be sure to mix the oil with the fuel. Are you
listening Dave and you other turbo users out there?

Paul Lamar


Paul and George, This plunger pump is a simpler variant of the pump used for mechanical fuel injection in some older cars. The lever arm, (controlled by the
throttle usually), varies the stroke of the pump. The worm gear is geared to the engine and varies with RPM. This is a true demand system. The output pressure
is usually varied by changing the headspace/clearance on the piston.
 I don't think there is anything wrong with using premix or using the pump. I think that the use of an external tank and 2-stroke oil is also a good solution,
provided you remember to fill the tank!
Bill Jepson


     It does not really pump hard. It is more like a distributor.
     It is fed by atmospheric pressure and not the engine oil
     pressure system. Back to premix to be safe and sure.

     Paul Lamar


 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.