I have been thinking about this some more and with a bit of software
I think the electric motor in the electric assisted turbo charger
can be used as generator. With a computer controlled clutch on
the turbo compound output shaft all sorts of possibilities become
available.
"Weinstock, Rob" wrote:
snip
This is a really interesting idea -- an electric turbo-compounder.
To me, the key question would be the continuous power rating of the
motor. My assumption is that this is intended for intermittent duty,
since it kicks in when the compressor needs to be accelerated, and the
mass being accelerated is relatively small.
The other technical problem to solve is one of controls for the
motor/generator. If it's a permanent magnet AC motor, a variable
frequency control will be necessary to regulate how much power is
extracted from the generator. For example, I was involved with an
electric car several years ago which had an AC induction motor. During
deceleration, we operated the motor in regen mode to recapture the
energy during braking and use it to recharge the main battery pack. This
could extend the range about 25%, but it was possible to lock the wheels
of the car during regen, depending on how aggressive a setting we
selected. If it's a DC motor, then the excitation has to be controlled.
i.e., an attempt to capture a lot of energy from the electric
turbocharger will simply stop the shaft from turning.
Finally, the efficiency of the motor has to be considered. While large
AC motors and brushless AC motors with exotic magnets can do better than
90%, small motors and DC motors are usually around 50-70%.
Regards,
Rob
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.