Subject: Supercharger verses the turbo charger
From: ACRE
Date: 8/4/2004, 9:16 AM

I have been thinking about this some more and with a bit of software
I think the electric motor in the electric assisted turbo charger
can be used as generator. With a computer controlled clutch on
the turbo compound output shaft all sorts of possibilities become available.

The turbo charger turbine could be sized not only to feed mechanical power
back into the e-shaft but could have the electric motor boost of the
turbo during acceleration AND a generator function during cruise.

That should gain a couple of more HP with a further lowering of the
BSFC. Assume for the moment the TC mechanical output assist is not used.
A 100 amp alternator generating 14 volts at 80% efficiency
is sucking down 1750 watts or 2.3 HP. Driving at night with headlights
could approach this condition. Since the car only needs about
30 HP on the freeway at constant speed this could be up to  a 7% reduction
if fuel burn right there. Almost 27 MPG rather than 25 MPG. Perhaps
a little less when you subtract the back pressure on the exhaust effect.

Perhaps the weight and cost of the separate alternator can be eliminated.
GM has already decided to eliminate the starter and use a starter/
alternator to start the car.

I am really excited about the possibilities here. This could be a sea
change in the automotive ICE as we know it. 

The Borman high speed generator if limited to 30K would need a gear box.
The electric assisted turbo charger motor on the other hand probably
already goes well over 100K RPM.

The 2005 electric assisted turbo charged RX8 is due to be introduced 
at the next Tokyo car show. I am thinking of coming over for that.

Paul Lamar

BTW the vote is moving towards the old way of doing things. When I quit
getting new votes I will count them up and make a decision but  not just based
on the vote but what I think is the best way for this newsletter.
 

Douglas Fir wrote:

Ok Paul,

I am still waiting to hear back from  Mazda engineers and set up a new
appointment. Right now that  area of Japan is getting pounded by heavy rains
and flooding. Two typhoons in one week.  After the next meeting I will
decide which engine to purchase to start some research with.  Probably a
cheap used 13B will suffice for turbo compound, bio fuel testing, and knock
noise analysis. If I screw up on the knock analysis it won't be as bad as a
playing with a new engine:)

I have done a little homework on brushless and permanent magnet motors
lately.  It would seem a more efficienct way to boost power and BSFC would
be as follows:

Connect the Borman highspeed generator to a turbo.  The generator can take
speeds up to and over 30K,rpm and with its high frequency controller can
operate in the high 90s % efficiency range. The energy is used to charge the
aircraft battery and drive an  electric powered supercharger.
This eliminates a heck of a lot of plumbing, intercoolers, and heat
management weight. The turbo doesn't need a waste gate because it won't
overspin as the load can be electronically managed and shunted, to numerous
loads.

  After I find out how much the hybrid car's 80mm wide AC motor weighs we
can look into the possibilities of replacing the flywheel, tossing the
starter, and have another place to  shunt power to. The electronic are
pretty much off the shelf or equipment my company is presently making in
Japan.

The voltage of the motor may be a sticking point. Most of these motors like
about 200 - 300 volts. The motor battery only needs to acts as a buffer
though to iron out spikes so it doesn't need to have very much capacitance.

Doug in Japan

From: ACRE <rotaryeng@earthlink.net>
Organization: ACRE
Date: Tue, 03 Aug 2004 16:44:19 -0700
Subject: Supercharger verses the turbo charger

According to Automotive News the European supercharger equipped
cars are completely switching over to the turbo charger.
Auto News did not say so but I'll bet the electric assisted
turbo charger is the one they are switching too. I can't wait
to drive a 2005 RX8 with an electric assisted turbo charger :)

We don't need the electric assist for aircraft use but at least
the Mazda rotary engine and turbo charger parts will be developed.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.