Subject: OSH P-port mufflers]
From: ACRE
Date: 8/6/2004, 4:20 PM


Or, perhaps have the input pipes of Paul's tangential muffler spiral in
different directions, so the pulses meet inside the can where they
cancel
each other out at a certain (cruise) rpm?

Scott Gettings


That certainly is an interesting idea. My guess it may kill
the noise but it will for sure kill the tuning as well :)

Paul Lamar

George Lendich wrote:

Scott,
I was musing over a the same idea, but for a different reason.
I felt that if someone wanted to uses the muffler at an angle to get around
fitting problems, you could set the muffler so that one entrance went in the
top side ( of the can) and the other entrance went in the bottom - thus
running the exhaust in opposite directions.
However my concern was what happens when they met in the middle of a side
exhaust or at the end of rear exhaust - most probably backpressure,
different exit tubes would fix that problem though, but that would eliminate
the homogenizing effect you suggest.
It may be worth a trial!
George (down under)

Speaking of the tangential tuned muffler I had a lot of complaints
saying it was impossible to weld so I came up with an idea
to make it easier. This is two inch tubing bent up on a 4 inch center
line radius with a six inch center can. Actually slightly less than
6 inch diameter. The can is fabed separately and holes cut and 
it is slipped in to the pre welded spiral tubes. Bolt holes are matched 
drilled and sheet metal screws are used to hold the can to the tube 
flanges. The sheet metal screw heads are drilled and safety wired.

The outlet pipe is best brought out of the front of the can with
a 180 out the side of the cowl with an optional fish tail
to cut the noise further. No problem to fit this in to a wide
Schertz beam motor mount without the P51 type MM beam feature shown
here.

Paul Lamar

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.