Subject: Supercharger verses the turbo charger
From: ACRE
Date: 8/6/2004, 9:56 AM


I have been thinking about this some more and with a bit of software
I think the electric motor in the electric assisted turbo charger
can be used as generator. With a computer controlled clutch on
the turbo compound output shaft all sorts of possibilities become
available.

"Weinstock, Rob" wrote:


snip

This is a really interesting idea -- an electric turbo-compounder.

To me, the key question would be the continuous power rating of the
motor. My assumption is that this is intended for intermittent duty,
since it kicks in when the compressor needs to be accelerated, and the
mass being accelerated is relatively small.

The other technical problem to solve is one of controls for the
motor/generator. If it's a permanent magnet AC motor, a variable
frequency control will be necessary to regulate how much power is
extracted from the generator. For example, I was involved with an
electric car several years ago which had an AC induction motor. During
deceleration, we operated the motor in regen mode to recapture the
energy during braking and use it to recharge the main battery pack. This
could extend the range about 25%, but it was possible to lock the wheels
of the car during regen, depending on how aggressive a setting we
selected. If it's a DC motor, then the excitation has to be controlled.
i.e., an attempt to capture a lot of energy from the electric
turbocharger will simply stop the shaft from turning.

Finally, the efficiency of the motor has to be considered. While large
AC motors and brushless AC motors with exotic magnets can do better than
90%, small motors and DC motors are usually around 50-70%.

Regards,

Rob


Paul,


If you do a Google on "switched reluctance alternators, or generators,
or machines, or motors" (SRG"S or SRM"S) you will find many studies and
examples of brushless,  fairly efficient, fault tolerant devices which
can spin at turbo RPM's. Some of the work is related to auto
starter/alternators, some is sponsored by Wright Patterson for 20-60 KW
generators direct coupled to jet engines. These can spin up to 200,000
RPM because there are no brushes, permanent magnets, or rotor windings.
One study considered 4130 steel rotor laminations. Not the best
magnetics but good enough at the required stress levels.

The concept is old but the advent of the latest generation of fast
switching, high current, IGFET's has led to practical implementations.
I've been looking at them for possible use as an integrated
starter/generator in my single rotor motor.

The problem with electricity is wires. They have resistance.
Resistance increases with heat. If you can figure
out how to remove the resistance all would be well :)
P = E x I    E = I x R    P = I^2 x R


Paul Lamar

Paul

Let me get this straight. You are saying that  a turbo driving a 10 to 1
reduction gear box with a overrun clutch coupled to a rubber belt operating
in a narrow operational rpm band of 3K to 4K rpm shaft speed is more
efficient in increasing shaft horsepower than a full range highspeed
generator (98%) driving a supercharger PM electric motor (70%)  via a power
conditioner/controller (95%)?  Lets assume we use  adequate sized wires in
the short wiring runs and leave off the liquid nitrogen. Besides everyone
knows liquid helium is lighter;-)

Ten years ago I wouldn't have hesitated to agree with you.  Now I am not so
sure.  I still am willing to test both ways though.

I have another company for you to call please. They are also in southern Ca.
but seem to have a wider range of products and experience than Borman Inc..
Interesting efficiency graph.

http://www.calnetix.com/efficiency.cfm

Doug in Japan

Rather spectacular claims. They are sending me more data on what
they have available to buy so you can buy one and test it.

Paul Lamar


If it is a generator they sell... you will need a 150 HP engine capable
of 60,000 RPM and a way of measuring the exact HP the engine is inputting
to the generator to test their extraordinary efficiency claims. GOOD LUCK :)

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.