McMaster Carr

Paul,  I just went to the McMaster Carr web site to order.  They have a
new page up on the Neoprene-Isolated rod ends which states the working
temperature is between 32ºF and 180º F.    I don't think we can  use
them.    Jerry

I think they are just being overly conservative. The vast majority
of engine mounts in the world are neoprene. I had a discussion with
them about that concerning the temperature rating of the pressure gauges.
They lowered the temp rating on those too. These mounts are so overkill
it is ridiculous. They are basically covering their butts as far as
their warrantee is concerned. If you are still not happy with this
use a metal 3/8 on the lower oil pan end and a 1/2 inch rubber on the top
end. The cool end. Same left and right hand thread scheme.
I am going to stick with rubber on both ends.

Paul Lamar

Charlie Smith wrote:

No, they are not being overly conservative.  Neoprene does not age very well in the presence of high temperature.  It will harden quickly and eventually crack and break into pieces.  This is also why 32°F is the low end for temperature.  Either way, the spring rate goes up to the point to where you might just as well have metal there.  If you must use Neoprene and have it placed near an exhaust pipe or manifold, please consider using a metal heat shield or inspect/replace often.

Charlie Smith
KIS Cruiser 4021

What type of rubber are they using for motor mounts Charlie?
Seems like all rubber turns to crap sooner or later.

I am not sure the rubber ball joint will run over 180 F anyway.
It is stuck out there on the back of the oil pan not near the exhaust.
True the oil can get over 200 F but the surface of the pan will
rapidly lose heat.

Well then use a steel ball joint on the lower end and
a rubber ball joint on the top end.

I'll still try it on the lower end and let people know what happens.
It won't be a catastrophic failure in any event and it is easily inspected.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.