> Funny you should mention it.  I have an Earl's cooler sitting around and was
     > considering mounting it to replace the broken Setrab.  The first thing I did
     > was cut off the mounting tabs.  It is only about 2/3 the size of the Setrab,
     > and I eventually decided not to mess with success.  I ordered a replacement
     > Setrab, but the first thing to go will be the mounting tabs.
     >
     > I plan to pro-seal some thick alum brackets to the sides, and make the
     > rubber thicker softer on my mounts, then build up JB weld around the
     > fittings like Tracy does.
     >
     > Dave Leonard

     Best not to risk those Earl's coolers. Lots of bad feedback on those
     and not just from the rotary guys.

     Paul Lamar

     I used the "JB Weld" fillets around the welded pipes on my water rads.  Don't forget the fiberglass in those fillets, that's where the real strength
     in them comes from.

     Tracy

The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.