Dear Paul
     >          I checked out the two co. you mentioned  and they have regular V
     > pulleys for auto use. What I am talking about is one flat belt driving
     > everything  plain and simple. Does any co. out there make such a set up. Has
     > any of the rotary people out there used alum under driven pulleys and if so
     > what has been thereopinion of them-  good or bad
     >
     > Regards
     >
     > Ed


Ed- go here-
Click here: Rx-7pulleys

There was some discussion as to whether these were hard anodised or not. I will need something along these lines as I have a 2.85/1 on my Gen 3.

Paul- did I do this right, or should I pull out the Kevlar t shirt?

Brian Trubee

Thats better but what is the go here click here?

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.