> Kevin & Kim wrote:
>
> Not sure if I asked this already,,,, This is a PC question with
airplane application.
> Does anodizing aluminum change the heat conduction property of
aluminum? Specifically, does an AL heat sink with an anodized surface
retain heat
more than
> the same with out hard surface annodization?
> Or, do different alloys of AL have different thermal
conductivity properties?
> Thanks.
> Kevin in Denver
Good question. A black surface radiates heat better than a silver
colored surface.
Paul Lamar
Paul,
Black anodize does radiate heat slightly better. Only when a thin
layer is used though. The use of more than about .0003-.0005 in.
insulates the transfer to a
draw. Lots of study was done for aircooled auto engines. Black body
radiation is a well studied fact. The problem is always with making a
thin enough coating
that still has a heat transfer in the same range as the base material.
Bill Jepson
-Dave Nieman wrote:
I just finished a infrared camera training coarse. Anything that is
shiny is a poor conductor of heat. All the show auto builders know
this... They make them shine but they can't get rid of the heat worth a
flip. All show and no go. Black will radiate heat better than a shinny
silver object. However it will do it even better if it is dull and or
not very smooth.
All objects have 3 characteristics. They reflect, transmit and emit
energy. A good reflector is a poor emitter or transmitter of heat
energy. A smooth shinny piece of aluminum for example would radiate heat
better if it was lightly sand blasted. A shiny surface works better as
a mirror (reflector) not a emitter or transmitter which is what you are
looking for when dissipating heat. You could paint it any dull color and
increase its ability to transfer heat. Or is you blast it you have no
worry of paint insulating the surface.
Dave Nieman
-Alex Madsen wrote:
It is true that black objects radiate better. However in the case of a heat
sinks and car "radiator" most of the area of the fin only "sees" another
fin. Therefore most energy radiated will be absorbed by another fin and you
will have no net heat transfer. Remember any energy radiated has to go
somewhere, and in the case of a radiator in a duct all the radiated energy
goes to its self or the duct. Also car radiators run at relatively low
temperature making radiation a small part of the total heat transfer. Car
"radiators" are unfortunately misnamed; they are primarily heat exchangers
not radiators. Most of the time it is not worth the energy and expense to
increase the emissiveity of a heat exchanger.
Alex Madsen
P.S. Just to clarify, as long as a surface is not shiny the roughness of the
surface does not mater. The only thing that matters is the area normal
(perpendicular) to the overall surface of the object.
Very educational and pertinent Alex. Well written. Thanks for uploading that.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.