Jerry Hey wrote:

Paul,  I just hung the engine in the new S-Beam mt.  No surprise there
is generous room around the engine but seeing it in reality does get
your attention.     The exhaust fits easily.  It looks like cooling air
for the exhaust can be routed front to back after all  without too much
trouble. I had given up on this possibility. There is a ton of room
under the engine for the rad and louvers within the stock cowl.

  In the last  two photos a  piece of all-thread through the Barry Mt
and a chunk of old hat section  are used as fixture to position the
Setrabs.  I can adust them vertically and pivot on the all thread.  At
first glance it looks as if the oil coolers will fit where I wanted
o.k.   Air will be ducted from the cheek inlets  through the coolers
and then out through louvers on the side,   maybe.  Still thinking
about that one.

For those who would like to build their own S beam engine mount,  I can
supply the S Beam with the bushings welded in and the Barry Mounts
installed.     And I can also supply  complete  engine mounts.   Jerry

Jerry Hey <j-winddesigns@thegrid.net>

Looks good Jerry. what was that last file. I could not read it.
does it have a . extension?

       
Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.