Jerry Hey wrote:

Paul,  Two j-pegs showing the rad positioned under the engine.  The
piece of sheet metal represents the top of the plenum.   Louvers, when
closed add 3/4 inch to the bottom of the radiator.   Do  you see
anything stupid going on here?   Stop me before it is too late.

This week end I plan to remove the engine and tear it down for the P
Ports.   I bought a pint of the 600 degree epoxy.  Cost $59.00 !!!!

Jerry

Check the viscosity on that stuff

Paul Lamar

I did.  It may or may not self level depending of air temp.  The tech
guy said to warm the resin to 100 degrees before adding the hardener
and just pour it in.      Jerry

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.