Subject: High speed planetary gear set]
From: ACRE
Date: 8/27/2004, 10:47 AM

Brian,

Please download this file. Most of the high speed gear engineering
data is out of date.  This paper deals with pitch line velocities of
25,000 ft per minute.

http://gltrs.grc.nasa.gov/reports/2002/TM-2002-211336.pdf

Synthetic oils are hardly ever mentioned. If we go from
24 mm to 18 mm pinion gear (sun gear) the pitch line velocity
goes down from 26,000 feet per minute to 19,000 feet per minute
at 100,000 RPM.

Top speed with most old gear data and lube is 12,000 feet per minute
and not using "Very High Speed" gearing.

Do you know where I can get a copy of the JIS precision standards?

Paul


OK Brian thanks.

We are on the cutting edge here :)

Paul

Brian Dengel wrote:

Paul,

As the sun gear has 3 points of contact the stress loading and tangential
forces are equally distributed 3 ways, but any individual tooth on the
pinion has a failure torque rating of 7 N-m. This rating is based on 2.3
teeth in mesh between the sun gear and one planet gear.

The formulas used to calculate torque capacity are based on several
conditions. One of these conditions is the maximum speed being less than
3600 rpm. After that point the formulas are for reference only and prototype
testing is required to determine the actual failure torques. As your
application will approach 100,000 rpm (27 times the formula limits) , we
feel that if you reduce the size of the planetary set without changing
material from carbon steel to high strength alloy steel, there will be
catastrophic failure of the system.

Regards,
Brian Dengel
Product Manager


-----Original Message-----
Sent: Friday, August 27, 2004 11:20 AM
To: Brian Dengel
Subject: Re: High speed planetary gear set

Thanks Brian. Got it.

Still the question about planetary torque since the pinion (sun gear)
is 7 N-m per tooth, won't the final set have a torque rating of
21 N-mm because there are three teeth in engaged?

Paul

Brian Dengel wrote:

Paul,

All of the details regarding this gear can be found at
http://www.qtcgears.com/KHK/newgears/KHK050.html

Regards,
Brian

Brian, what about this? I can't find anything on the web site about
the "stock spur gear SS2-54 lists for $52.81"

Paul Lamar

ESI wrote:

Paul
Are the gear you quoted case hardened? Any luck finding bearings for the
gears.

Best Regards

Doug

310 470 0977
310 245 5508 cell
rotaryeng@earthlink.net
Lamar Instruments

--