Jerry Hey wrote:

Paul,  can  you give me the exact locations for the lower center
engine
attach points?   Are there clearance issues I should be aware of?
Thanks,  Jerry

Here is your drawing and a drawing of what I did.
My drawing shows the holes inside the front motor mount brackets
but it will work just as well with them out side the brackets.
Here too is the firewall dimensions that came with the KIS Cruiser.

Unfortunately I don't have the drawing on the position of the brackets
here so perhaps Charlie can send you a sketch. Maybe later today I can
get that
info.

Paul Lamar

Thanks Paul,   Location of these two points  will complete the picture.
   If no other compromises are involved, I like the outside position
better because  the tubes are well clear of the pan.   Could you
provide a drawing with both positions indicated?    Thanks,  Jerry

OK I'll do a 3D in the next day or so. In the mean time if you make them
9.5 inches apart you will safely clear the noes gear mounting brackets.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.