Vance W Jaqua wrote:
Paul - After burrowing deeply into my messy files - I believe
that I have found the CD i question. I had opened the envelope
but I am pretty sure that I had not installed it. I viewed the
contents, and it does look fairly promising - it looks like
you can at least make an MPEG from the video. I could not
find a readme nor identify a n acrobat file that looked like
the manual you mentioned - but this was just a quick look
we will have to figure out the best way to get it into
your hands - Vance (the disorganized packrat)
Thanks Vance I will come out tomorrow and pick it up.
We went out to Agua Caliente strip yesterday and shot some stuff
in late afternoon.
Lighting was not good. We stayed over night and shot some more at
6:15 AM right at sunrise. It is going to be wonderful.
I'll upload some short video clips we recorded with Robin's still
camera later today. (Yes it can do short video clips.) I want to warn you
we did it with the PT Cruiser and not the RX8 as Mikey came with
us and he is not comfortable in the RX8. However he never complains :)
The shot with Dave taking off behind the RX8 will be just spectacular
if we can get it timed right. The camera will be low on the center
line of the runway as I accelerate down the strip in the RX8 and
Dave takes
off over me and keeps it at about 15 feet above the runway until
past the camera. We will try three different zooms with three
takeoffs and landings. Can you do that Dave?
In the mean time I'll try not running over your camera Vance.
I am going to write a QB program assuming
a constant thrust and gross weight for Dave's airplane and based on
the measured acceleration of the RX8. What speed do you rotate at Dave?
I think Dave needs to delay taking off after
me for a second or two. We will get a better handle on that shortly.
Paul Lamar
Paul,
Sounds like a lot of fun. I got up today for the first time since the oil
cooler leak. Sure was great to get back in the air. All systems go. The
cowl flap is back on. I like the looks better and it does seem to cool
slightly better with the flap on, especially in high AOA activities like
loops.
The biggest possible snarl for Monday is the marine layer. I am fairly
aggressive about getting out under it, but not in the dark. We'll just have
to wait and see. I may even be getting out before it rolls in.
I am a little nervous about the safety of the shoot. After all, neither of
us are professionals and the runway is rather narrow. I am not adverse to
taking off with you on the runway, but please don't take offense if I drill
the plan over and over.
I rotate at about 65 KIAS, which will be a little higher ground speed
because of the elevation. I could probably rotate slower, even down to 55
with a little bit of flaps if needed.
My take off distance is never the same twice. Since I can't use full
throttle I slowly ease it in to make sure I don't overboost. Depending on
my mood and weight and final boost setting that can make a big difference in
take off distance.
It may be easier and safer for me to do low approaches. That way I can do
them all the same, and you will be the only one who has to coordinate the
timing. After a few tries you should be able to pin down some timing cues.
That will also go quicker as you wont have to wait for me to land and taxi
each time. I could also carry some smash into some of the approaches and do
a high performance climbout :-)
What time did the sun come up when you were out there? What time do you
think I should get there?
Dave Leonard
Runway is real wide. Room for two RV6s to take off side by side.
Also very smooth with no cracks. I was impressed with the shape it is in.
We can try several things. We can space the RX8 ahead by several hundred feet.
The RX8 will reach sixty in about 6 seconds and well over 100 MPH in the 1/4
mile so I don't think you will catch me before you take off or by the end of the
2500 foot runway. I can run down the left side and you can fly down the
right side if you wish. We can sneak up on this and make a few conservative
trial runs. We can also do some buzz jobs at speed on the road.
If you and your wife want to fly out the night before Robin and I
will pick you up at the El Centro airport.
We will stay at the Vacation Inn. $50 a night. Nice rooms. Cheap for
the time and money we have invested in this project.
We can shuttle you guys to the El Centro airport at 5:00 AM.
You can then leave at about 6:00 AM for the 15 minute flight
over to Agau Caliente and land there.
Robin and I can then be in AG at 6:00 AM in the RX8. Takes about 45 minutes
to drive out. Sun comes up about 6:15 but there is plenty of light
to land at AG at 6:00 AM. We can delay this an hour or so but
camper activity in that area may increase.
We can exchange cell phone number and radio frequencies.
I have a new hand held I bought at the Camarillo air show on Sat.
Here is a sort trial video clip in .vi ArcSoft format. As far as I can tell
there are about 3 dozen competing video formats and Arcsoft can only
save as .vi. Sorry about that. I am new to video editing. I should
have some other formats in a day or so. Perhaps somebody on here
can convert this to a more popular format.
Also a few pictures and some excerpts from the trial video.
As soon as you take off behind the RX8 your airplane should appear in the frame
just above the RX8 if you keep it down to about 15 or 20 feet it
should appear in most of the rest of the frames.
Paul Lamar
I finally found a movie file format that a mother can love.
Should work on just about everybody's computer.
Picture the RV6 rising above the car and rapidly over flying it.
Paul Lamar
I was going to suggest mpg, but you beat me to it! <G> Looks like a good location, Paul...must be Wonder Woman's glass plane, and that sure was a funny
looking RX-8, tho <VBG>
Harley
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.