Douglas Fir wrote:
Paul and everybody
Here is a brain teaser for you. Does a boosted 3 rotor strolling along at
3000 rpm and producing 165Hp get better gas mileage then a boosted 2 rotor
lopping at 4300 rpm producing 165Hp?
Here is the situation. Many of us need 300hp in our heavier planes for them
to climb adequately in critical flight situations. If we go with a N/A
street ported 20B with an efficient muffler the issue is solved but we can't
fly very high. However if we choose a 20B and turbo it the engine will
produce way more power than we need (400 to 450hp) and therefore we could
say we are carrying a 140 lb. weight penalty for a an unneeded potential.
If turbocharged we will be running the 20B at very low rpms (about 3000)
or lower to bring it down to economy cruise of 165 hp. That is what
Lycoming IO-540 equipped planes fly at when near the 55% power setting.
The alternative is to lighten up the plane substantially by running the
boosted Renesis at 4300 rpm and the same hp. If boosted it would produce
about 330 @ 8500rpm. 220hp x 1.5 = 330. Because of prop speed limits the
engine top end is limited to around 7800 which equals about 300hp. Actually
the Renesis six port is rated higher but I am going with Jim M. recent dyno
test results.
Adding in a conservative 10% increase in torque from turbo compounding and
the rpms would lower the BSFC. Soo..... the million dollar question
is....assuming the fuel is gasoline, Is it better to flog the dog
occassionally or throttle the beast most of the time?
Doug
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/‾rotaryeng/
Copyright 1998-2004 All world wide rights reserved.