Subject: safety wiring Ross prop bolts
From: ACRE
Date: 9/5/2004, 6:35 AM

paul wrote:

Hi all....On a typical aircraft prop installtion, the heads of the prop
bolts are drilled and then safety wired. This works, because the prop flange
has fixed threaded sleeves into which the prop bolts fasten.  On my Ross
PSRU, there are thru-bolts, and instead of the bolts being threaded into a
fixed unit, they go through the crush plate on the engine side of the prop
and have locknuts instead.  What might be the best method of securing these
type of prop bolts?  Unfortunately, I have seen a few other rotary
installations with a Ross redrive, but never bothered to look to see if the
prop bolts had safety wire, etc.  Thanks for any and all suggestions. Paul
Conner, 13b powered SQ2000 transporting to the airport today.

In theory if you have lock nuts you don't need safety wire.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.