Subject: P port fuel injection
From: ACRE
Date: 9/6/2004, 7:45 PM


Jerry Hey wrote:

Paul, is there any way to  use two  of the  Mazda  primary injector
fuel rails  one with each of the  the p port runners.?  Each would
have
one high flow and one low flow injector?

  Is it important to inject the fuel in line with the air flow
through
the runner, or can it be injected at an angle say 90 or 45 degrees?

   Jerry

The center to center distance on a 1988 turbo fuel rail is 6.25
inches
roughly. What is the center to center distance on your P-port tubes?

You want to get it as close to inline as you can. Mazda uses a
special
plastic insert with the 90 degree injectors mounted  in the center
housing.

Paul Lamar

 Jerry,
 Have you considered mounting the injectors directly opposite the
bellmouth
openings of the runners (on/in the intake plenum) - room permitting.
This
gives the straightest line one can get or get a set of Paul's runners
with
bellmouth and fuel injector mounts.
George (down under)

I   have started thinking about putting the injectors INSIDE the bell
mouths.  There is a compelling reason to do this
in that I want the runners to be a little less than 27 inches from
butterfly to bellmouth  but it is very difficult to keep
them that short.   We were going to turn the runners downward on the
cool side and install the injectors in the
turned down portion directly in line with the main runner but this
produces a runner that is too long.   Paul's runners will not work with
the p port.

Paul has some good suggestions that I need to think about and Ed is
working on this too.  Hopefully we will come up with something good.
  Jerry

27 inches is too long Jerry. 22 inches for 6000 RPM and something less for 2.85:1
gear box and 7500 RPM. If you put them in the bell mouths they will restrict
the airflow and spew fuel back because of the organ pipe tuning.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.