Subject: P port fuel injection
From: ACRE
Date: 9/6/2004, 6:41 PM


Jerry Hey wrote:

Paul, is there any way to  use two  of the  Mazda  primary injector
fuel rails  one with each of the  the p port runners.?  Each would
have
one high flow and one low flow injector?

  Is it important to inject the fuel in line with the air flow through
the runner, or can it be injected at an angle say 90 or 45 degrees?

   Jerry

The center to center distance on a 1988 turbo fuel rail is 6.25 inches
roughly. What is the center to center distance on your P-port tubes?

You want to get it as close to inline as you can. Mazda uses a special
plastic insert with the 90 degree injectors mounted  in the center
housing.

Paul Lamar

the distance between centers is approx. 5.25"   The injector side of
the intake is the last unresolved design issue.   I hope  you can help
out because it is whipping me daily.

  What do  you think of these two photos?    
Jerry

The photos are fine Jerry. Your throttle arms are a bit longer than necessary.

Now all you need are a couple of 180 tube bends and bell mouths.

Get Ed to weld on injector bungs and bell mouths. You can weld the bungs
on top or on the side at an acute angle. If done on the side they can be AN-6 
plumbed individually using this device shown in the 3D.

You could also make them out of steel tubing for testing and a trial fit.

Paul Lamar
 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.