Subject: P port fuel injection
From: ACRE
Date: 9/6/2004, 6:41 PM


Jerry Hey wrote:

Paul, is there any way to  use two  of the  Mazda  primary injector
fuel rails  one with each of the  the p port runners.?  Each would have
one high flow and one low flow injector?

  Is it important to inject the fuel in line with the air flow through
the runner, or can it be injected at an angle say 90 or 45 degrees?

   Jerry

The center to center distance on a 1988 turbo fuel rail is 6.25 inches
roughly. What is the center to center distance on your P-port tubes?

You want to get it as close to inline as you can. Mazda uses a special
plastic insert with the 90 degree injectors mounted  in the center
housing.

Paul Lamar

 Jerry,
 Have you considered mounting the injectors directly opposite the bellmouth
openings of the runners (on/in the intake plenum) - room permitting. This
gives the straightest line one can get or get a set of Paul's runners with
bellmouth and fuel injector mounts.
George (down under)

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.