George Lendich wrote:

Paul and those interested!

How's the bellhousing looking with the Ribs and Fillets.
A fair bit of tidying-up yet to be done.

I will leave the flange (cut to size) last as the sheet of fibreboard

is prone to warping, if it's not all held in place, as it's quite thin.

I will probably leave that for a couple of days now.

It's starting to look very futuristic! - and MEAN!
George (down under)

You are doing a excellent patternmaking job George! I am interested for my 20B in the RV-10. All the work you have
done to make the pattern accurate will pay off  later in lower machining cost when finishing. Keep up the good work.
Bill Jepson

 
The Rotary Engine NewsLetter.  Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/            
Copyright 1998-2004 All world wide rights reserved.