Now all you need are a couple of 180 tube bends and bell mouths.
Get Ed to weld on injector bungs and bell mouths. You can weld the bungs
on top or on the side at an acute angle. If done on the side they can be AN-6
plumbed individually using this device shown in the 3D.
You could also make them out of steel tubing for testing and a trial fit.
Paul Lamar
Looks great Jerry. Question for Paul. Is the center injector tube metal? To clarify, is the infeed tube to the injector with the little o-ring, (where the fuel rail would normally mount), made of
steel or aluminum? If so we could use a Swagelock fitting to plumb to the feed lines. Swagelocks are designed for exactly this environment, sealing tight in a pressure environment.
Bill Jepson
Some injectors are plastic. The ND used by Mazda on the rotary looks to be steel or
powdered iron.
BTW this 3D was the original casting idea and still can be welded up.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://home.earthlink.net/~rotaryeng/
Copyright 1998-2004 All world wide rights reserved.